Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ASA switching over from Active to stanby

If I shuthown a monitored physical interface, the active ASA doesn't swtich over to standby.

Shutdown also brings the communication down. It should also be considered as reason to trigger the failover.

3 REPLIES
New Member

Re: ASA switching over from Active to stanby

check your failover config...

Re: ASA switching over from Active to stanby

New Member

Re: ASA switching over from Active to stanby

What does the show fail command show about the standby firewall?

Is this a LAN based failover?

Make sure that you see traffic from the other firewall on the sync interface (dont look at interface stats, do a capture).

120
Views
0
Helpful
3
Replies