I have a couple of ASA clusters. To make the firewall policy easier to read I use the "name" command to associate names to IP's and then use the names in the firewall rulebase.
Whenever the ASA sends logs to syslog it is sending that actual text name that I've associated with the IP and not the IP itself. My log aggregation device then has issues parsing the syslog message for source and destination IP.
Is there any way to change the ASA to log IP and not name?
I don't see anything in the command reference that suggests this is possible. I think the only way to do this would be to use the 'no names' command and only enabled 'names' when you are actively looking at the configuration.
This sounds like it would be a good case for a feature request though.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...