Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

ASA5505 dual ISP both with PPPOE setroute on both interfaces

I would like to setup an ASA5505 with dual ISP connections.  Both of the internet connections authentication and obtain their IP address and default route using PPPOE setroute. When I have configure dual ISP support on ASA's in the past I would normally use the sla monitoring and track commands as below but because the default routes in this case are set using PPPOE it isn't possible to manually define the default routes as with the example below.

As this is a 5505 I will use the backup interface command on the primary outside interface. Is this all that is required?  Is there a way of configuring an SLA monitor to track using PPPOE setroute on both interfaces?

Normal static IP address example

route outside 0.0.0.0 0.0.0.0 10.200.159.1 1 track 1
route backup 0.0.0.0 0.0.0.0 10.250.250.1 254
sla monitor 123
type echo protocol ipIcmpEcho 10.0.0.1 interface outside
num-packets 3
frequency 10

sla monitor schedule 123 life forever start-time now
track 1 rtr 123 reachability

Any assistance would be much appreciated.

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: ASA5505 dual ISP both with PPPOE setroute on both interfaces

Hello,

If you do not have license restriction (Security Plus License), then you can

use the track option under PPPoE as well.

interface VLAN 2

ip address PPPoE setroute

pppoe client route track "track id"

interface VLAN 3

ip address PPPoE setroute

pppoe client route distance 254

Hope this helps.

Regards,

NT

2 REPLIES
Cisco Employee

Re: ASA5505 dual ISP both with PPPOE setroute on both interfaces

Hello,

If you do not have license restriction (Security Plus License), then you can

use the track option under PPPoE as well.

interface VLAN 2

ip address PPPoE setroute

pppoe client route track "track id"

interface VLAN 3

ip address PPPoE setroute

pppoe client route distance 254

Hope this helps.

Regards,

NT

New Member

Re: ASA5505 dual ISP both with PPPOE setroute on both interfaces

Thank you, that is what I was looking for.

2531
Views
0
Helpful
2
Replies
CreatePlease to create content