Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

asa5505 upgrade problem

I'm still running asa723-k8.bin. I've just copied asa804-k8.bin to an ASA5505 trying to upgrade. My problem is that if I now do a 'wr mem', I get the following.

Building configuration...

Cryptochecksum: 42f9323 .....

%Error opening disk0:/~/asa804-k8.bin (Directory doesn't exist)

Error executing command

[FAILED]

sh running-config works, but if I do a 'sh startup-config', nothing is printed.

Any ideas?

7 REPLIES
Green

Re: asa5505 upgrade problem

Appears the asa804-k8.bin is not in the proper directory. Do a "dir flash:", you should see the .bin file there. If not, copy it again to the proper directory. disk0:/asa804-k8.bin

Community Member

Re: asa5505 upgrade problem

I do a 'dir flash:' and I see the asa804-k8.bin file in the listing w/ the other files. I've recopied and get the same results.

Green

Re: asa5505 upgrade problem

What about...

boot system disk0:/asa804-k8.bin

Community Member

Re: asa5505 upgrade problem

That command seems to run fine, I execute it, and it just returns to the prompt. However, I still have the previous errors.

And if I run the command a second time, I get:

Error: Unable to set this url, it has already been set

Remove the first instance before adding this onoe.

Green

Re: asa5505 upgrade problem

show run boot

If you see "boot system disk0:/~/asa804-k8.bin" then get rid of it.

no boot system disk0:/~/asa804-k8.bin

Community Member

Re: asa5505 upgrade problem

Thank you, that fixed it.

Green

Re: asa5505 upgrade problem

No problem. If you use the ASDM you will also need

asdm image disk0:/asdm-613.bin

Please rate any helpful posts.

526
Views
10
Helpful
7
Replies
CreatePlease to create content