Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ASA5505 VPN Remote Access

hello,

I'm having problems setting up an ASA5505 VPN Remote Access with Cisco VPN Client 5.01.0600. ASA5505 is 7.2 Software with K9. I get this message in the log: Group = Test, IP = x.x.x.x, Removing peer from peer table failed, no match! I set up a test IKE policy that uses 3des/md5, DH group 5, and preshare. The test group policy uses IPSec as the tunneling protocol. Any hints would be great. thank you

1 REPLY
Silver

Re: ASA5505 VPN Remote Access

If you are facing authentication problem check if you have configured the commands "authentication-server-group" and "default-group-policy". Also make sure that Split tunnel and relevant access-lists are configured properly. Following link may help you

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a008046f307.shtml

116
Views
0
Helpful
1
Replies
CreatePlease login to create content