Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

ASA5508 with 8.3.2

Dear All,

I have a ASA5508 running in 8.3(2) and without enable NAT. If I do a static network address translation for a inside address. any Implict rule in xlate?

In another words, what is the forwarding rule ASA choose while there is routing exist and NAT? Do I need to setup bypassing NAT? Thanks!

Everyone's tags (3)
3 REPLIES

ASA5508 with 8.3.2

Hello Nick,

Can you ask the question again, I do not understand what you are looking for,

Regards,

Julio

Julio Carvajal
Senior Network Security and Core Specialist
CCIE #42930, 2xCCNP, JNCIP-SEC
New Member

Re: ASA5508 with 8.3.2

Presently, asa is running in routing environment. I want to translate a ip address within the subnet to a outside address. Will it affect the routing table?

In pre 8.3, I know we need to do bypassing NAT. I don't know how to do it in 8.3.2.

Purple

ASA5508 with 8.3.2

Hi,

so firewall is in routed mode and with default no nat-control and you want to do a static NAT config  from inside to outside?

Then just do it and configure an ACL permitting this traffic( you'll have to use the non natted ip address) and apply it inbound on the outside interface.

Regards.

Alain

Don't forget to rate helpful posts.
410
Views
0
Helpful
3
Replies
CreatePlease to create content