Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

ASA5510 Limit Inbound and Outbound Bandwidth

We have an ASA in a colo environment that has a full 100Mbps Internet connection. we are billed at a 95th percentile rate and want to limit ourselves to 34Mbps. I believe this can be done by traffic shaping. I want all traffic affected by this. Our inside is split up by 4 different vlans. I have a feeling this makes this more complicated.

Does this example I found do what i want (except for the bandwidth being off):

pixfirewall(config-pmap)#policy-map PM-SHAPER

pixfirewall(config-pmap)# class class-default

pixfirewall(config-pmap-c)# shape average 2000000 16000

pixfirewall(config-pmap-c)# service-policy PM-SHAPER interface outside

Thanks in advance!

1 REPLY

Re: ASA5510 Limit Inbound and Outbound Bandwidth

I don't believe you can shape, but you can police. Here's an example and link.

access-list policed_traffic extended permit ip any any

class-map PM-Shaper

match access-list policed_traffic

policy-map PM-SHAPER

class PM-Shaper

police output 20000000 10000

service-policy PM-SHAPER interface outside

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a008084de0c.shtml

Hope that helps.

617
Views
0
Helpful
1
Replies
CreatePlease to create content