I was testing different options in our new ASA5520 by setting up failover active/active (currently not in production). I was setting things up using the ASDM. For failover active/active, the ASA was switched multi-mode and rebooted. However, I am unable to get back to the "single router mode" when I issue the command "configure factory-default".
ciscoasa(config)# configure factory-default
ERROR: Command can only be executed in single router mode
I need to clear out the existing config and get back at the factory default level, does anyone know how? Please help.
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...