Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
it
Community Member

ASA5520-K8 7.0(6) asdm 5.0 missing Interface configuration commands

Hello,

I trying set mac address on the interface

<code>

Firewall/admin(config)# interface gigabitEthernet0/2

Firewall/admin(config-if)# ?

Interface configuration commands:

  asr-group        Configure Asymmetrical Routing group id

  default          Set a command to its defaults

  description      Interface specific description

  exit             Exit from interface configuration mode

  help             Interactive help for interface subcommands

  ip               Configure ip addresses.

  ipv6             IPv6 interface subcommands

  management-only  Dedicate an interface to management. Block thru traffic

  nameif           Assign name to interface

  no               Negate a command or set its defaults

  security-level   Specify the security level of this interface after this

                   keyword, Eg: 0, 100 etc. The relative security level between

                   two interfaces determines the way the Adaptive Security

                   Algorithm is applied. A lower security_level interface is

                   outside relative to a higher level interface and equivalent

                   interfaces are outside to each other

  shutdown         Shutdown the selected interface

</code>

I found how to set mac address with command mac-address but I don't have it in there.


http://www.cisco.com/c/en/us/td/docs/security/asa/asa72/configuration/guide/conf_gd/intparam.html

Thank you for any hint how to solve it.

Everyone's tags (4)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

ASA5520-K8 7.0(6) asdm 5.0 missing Interface configuration comma

Hi ,

As per your query , the MAC address command is not supported on your current version and is available from ASA 7.2.1 onwards .

Check this:-

http://www.cisco.com/c/en/us/td/docs/security/asa/command-reference/cmdref/m1.html#pgfId-2111047

Thanks and Regards,

Vibhor

1 REPLY
Cisco Employee

ASA5520-K8 7.0(6) asdm 5.0 missing Interface configuration comma

Hi ,

As per your query , the MAC address command is not supported on your current version and is available from ASA 7.2.1 onwards .

Check this:-

http://www.cisco.com/c/en/us/td/docs/security/asa/command-reference/cmdref/m1.html#pgfId-2111047

Thanks and Regards,

Vibhor

238
Views
5
Helpful
1
Replies
CreatePlease to create content