Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ASA5520 Problem

Hi dear all :

I have a strange problem , when I try to save my configuration on the asa5520 I get the error massege that say

"%Error reading system:/running-config (Configuration line too long)

Error executing command

[FAILED]"

I check the memory and cpu and I fine it is ok and there is a space

so any one can help please?

1 ACCEPTED SOLUTION

Accepted Solutions
Gold

Re: ASA5520 Problem

It looks you are hitting bug CSCsg87808

Taken from Cisco Bug tool

CSCsg87808 Bug Details

'wr mem' fails due to snmp config; Error: (Configuration line too long)

Symptom:

If snmp-server commands are configured, in a rare corner case

the configuration might fail to save to flash and give the error like below:

pix# wr mem

Cryptochecksum: ee8f5816 e1ce1ad7 83151424 f1a3b6fc %Error

reading system:/running-config (Configuration line too long)

Error executing command [FAILED]

Conditions:

The firewall must have snmp-server commands configured and running

version 7.2(1)25 or greater (includes 7.2(2)).

Workaround:

Remove the snmp-server commands from the configuration

-or-

downgrade to a version of code previous to 7.2(1)25

2 REPLIES
Gold

Re: ASA5520 Problem

It looks you are hitting bug CSCsg87808

Taken from Cisco Bug tool

CSCsg87808 Bug Details

'wr mem' fails due to snmp config; Error: (Configuration line too long)

Symptom:

If snmp-server commands are configured, in a rare corner case

the configuration might fail to save to flash and give the error like below:

pix# wr mem

Cryptochecksum: ee8f5816 e1ce1ad7 83151424 f1a3b6fc %Error

reading system:/running-config (Configuration line too long)

Error executing command [FAILED]

Conditions:

The firewall must have snmp-server commands configured and running

version 7.2(1)25 or greater (includes 7.2(2)).

Workaround:

Remove the snmp-server commands from the configuration

-or-

downgrade to a version of code previous to 7.2(1)25

New Member

Re: ASA5520 Problem

Thank you M.Sir:

Yes the snmp-server command was the problem

I remove the command and it is work ok , so thank you frined I have rate your solution

emad Frag

187
Views
0
Helpful
2
Replies