Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

ASA5520 SSH access

Dear all

I am adding a new jump station to the network which is supposed to connect via ssh only to ASA.

using ASDM, I add teh host address of jumpstation under properties, device access, secure shell and apply. easy enough, but does not work...any suggestions ?

TIA

Sam

2 REPLIES

Re: ASA5520 SSH access

Sam, I assume you have configured crypto keys for ssh access as this is required for ssh access to security applience. If you have done so on this part I would then believe something wrong in your ssh added statement rule.

asa(config)#ssh < mask>

make sure ssh statement for jumpstation is comming from correct nameif interface.

examples

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a008069bf1b.shtml

regards

Re: ASA5520 SSH access

Thanks for the response !

I found out teh config was correct, but DNS was point at wrong FW interface. and therfeore requests are dropped.

Sam

180
Views
3
Helpful
2
Replies