01-15-2009 03:18 AM - edited 03-11-2019 07:37 AM
Dear all
I am adding a new jump station to the network which is supposed to connect via ssh only to ASA.
using ASDM, I add teh host address of jumpstation under properties, device access, secure shell and apply. easy enough, but does not work...any suggestions ?
TIA
Sam
01-15-2009 04:41 AM
Sam, I assume you have configured crypto keys for ssh access as this is required for ssh access to security applience. If you have done so on this part I would then believe something wrong in your ssh added statement rule.
asa(config)#ssh
make sure ssh statement for jumpstation is comming from correct nameif interface.
examples
regards
01-15-2009 05:12 AM
Thanks for the response !
I found out teh config was correct, but DNS was point at wrong FW interface. and therfeore requests are dropped.
Sam
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: