I would think that one of these parts would be the rack kit used when eliminating the slide rails to fit the 5585 in a narrow rack as described in the hardware installation guide ( http://www.cisco.com/c/en/us/td/docs/security/asa/hw/maintenance/5585guide/5585Xhw/procedures.html#79288 )
Rack-Mounting the Chassis Using the Fixed Rack Mount
If you are not able to use the slide rail kit in your rack installation, an optional fixed rack mount solution is available. You can install fixed front and rear rack mount brackets on the ASA 5585-X so that you can easily mount it in a rack.
OK, that is what I want, but what part is it? Is it one of the three below? Is it something else?
The RAILS part is the standard slide rail kit with the ball bearings etc. that allows the ASA to slide in and out without unmounting.
The REAR-RACK is the little guide pieces that attach to the ASA plus the longer bits that attach to the rack's rear posts to give the unit support on the rear. It's sold separately in case someone started out with the kit below but only used the front hardware and the rear bits went missing if/when they decided they should add them.
The RACK-KIT includes the REAR-RACK pieces plus the big rectangular pieces with ears that attach on the front sides of the ASA and allow you to secure it into your front posts.
DocumentationCode download linksGoalRequirementLimitationsSupported ISR
and UCS-E ModelSupported ISRG2 and UCS-E Blades:Supported ISR4K and
UCS-E Blades:Step by Step ConfigurationConfigure one of the connectivity
options to access the Cisco IMC from the n...
Firepower Threat Defense (NGFWv) on UCS E-series - Transparent Mode in
HA DocumentationCode download linksGoalRequirementLimitationsSupported
ISR and UCS-E ModelSupported ISRG2 and UCS-E Blades:Supported ISR4K and
UCS-E Blades:Step by Step ConfigurationCo...
Question I am currently unable to specify "crypto keyring" command when
configuring VPN connection on my cisco 2901 router. The following
licenses have been activated on my router :