Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ASDM 6.4 for ASA "Public Servers"

Hello again!

I want to open a bunch of ports to "the public" and point them to my internal server (192.168.2.39)

error.jpg

I tried to add it in the "Public Servers" pane, but I get an error "The public address cannot be the same as the public interface address.".

I only have 1 public IP-address, so what to do ?

Thanks in advance!

Best regards

\L

1 REPLY

ASDM 6.4 for ASA "Public Servers"

Hello Lukas,

Then configure manually the NAT rule and the ACL.

On the nat rule you will use the keyworkd "interface" for the IP address.

Rate all of the helpful posts!!!

Regards,

Jcarvaja

Follow me on http://laguiadelnetworking.com

Looking for some Networking Assistance? Contact me directly at jcarvaja@laguiadelnetworking.com I will fix your problem ASAP. Cheers, Julio Carvajal Segura http://laguiadelnetworking.com
93
Views
0
Helpful
1
Replies