Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ASDM authenticate fails now

Hello, I need some help getting my ASDM working again.

For some reason when I try used ASDM I can't get pass the authenticate part. 

When I try to ssh to the same firewall using the same username and password worked fine no issue.

ASDM version 712-102 

Any ideas to get this to work again would be helpful

 

 

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Do you have the following

Do you have the following required setting:

     aaa authentication http console LOCAL

(the LOCAL is case-sensitive)?

4 REPLIES
Hall of Fame Super Silver

Do you have the following

Do you have the following required setting:

     aaa authentication http console LOCAL

(the LOCAL is case-sensitive)?

New Member

here is my setting aaa

here is my setting 

aaa authentication http console radius LOCAL

 

Hall of Fame Super Silver

OK, that will work as long as

OK, that will work as long as you have a working RADIUS server configured.

If the RADIUS server cannot be reached, the ASA will fallback to local authentication.

If the RADIUS server is reachable but not authenticating you then the ASA will not fallback to local.

Can you confirm you are using your credentials authenticated by the RADIUS server for ssh? If you are then you should see authentication attempts logged on the RADIUS server when trying to login via ADSM (which uses https).

New Member

Well, I check the setting

Well, I check the setting between the HTTP and SSH on the show run aaa command 

I found that radius is not setup up on the SSH it points to a LDAP server which is not working then it fails to local.

So I check the radius server it is not working correctly AD but of the server is having errors. I don't understand why if the radius server is not working right that local is not working right.

So I took out the radius command to make it default to local user only 

It work

88
Views
5
Helpful
4
Replies
CreatePlease to create content