Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

ASDM - How to run multi versions

We have serveral ASAs installed and adding more. Of course the new boxes have a new version of ASDM. How can I access both the older and newer versions of ASDM?

Thanks Mucho!!!!

1 ACCEPTED SOLUTION

Accepted Solutions

Re: ASDM - How to run multi versions

Here's an example-

Cisco ASDM 6.1(5) is a web-based application to configure and monitor the ASA/PIX security appliance running version 8.0 or 8.1. ASDM 6.1(5)51 is an engineering build based on the ASDM 6.1(5) release.

6 REPLIES

Re: ASDM - How to run multi versions

You would have to change the config to point to the one you want.

asdm image disk0:/asdm-613.bin

or

asdm image disk0:/asdm-603.bin

Why not upgrade all the boxes to the latest or a version you're comfortable with?

Community Member

Re: ASDM - How to run multi versions

Collin, thanks for your reply! Is the ASDM Image dependent on the version of code that the ASA is running?

Re: ASDM - How to run multi versions

Yes, you will have to read the release notes. It will tell you which versions are supported.

Re: ASDM - How to run multi versions

Here's an example-

Cisco ASDM 6.1(5) is a web-based application to configure and monitor the ASA/PIX security appliance running version 8.0 or 8.1. ASDM 6.1(5)51 is an engineering build based on the ASDM 6.1(5) release.

Community Member

Re: ASDM - How to run multi versions

Collin, thanks for your help with this issue!!!

Re: ASDM - How to run multi versions

No problem.

149
Views
0
Helpful
6
Replies
CreatePlease to create content