Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

ASDM HTTP access error

Hi,

I have two ASA5520 in a current, operational failover configuration.

I am trying to enable http access so that I can use ASDM to monitor health & logs.

Both appliances have are running 8.0(2) and have ASDM-6.2 loaded. See below;

boot system disk0:/asa802-k8.bin

boot system disk0:/asa722-k8.bin

boot system disk0:/asa704-k8.bin

asdm image disk0:/asdm-602.bin

However, when I try to allow access to the appliance from a specific subnet using...

http 10.1.1.0 255.255.255.0 Corporate

I get this error...

ASA1(config)# http 10.1.1.0 255.255.255.0 Corporate

Could not start admin

ASA1(config)#

Has anyone seen this "coiuld not start admin" error before?

Thanks,

DH

1 REPLY
Gold

Re: ASDM HTTP access error

congratulations...it sounds like you hit a known bug.

http://www.tek-tips.com/viewthread.cfm?qid=1419872&page=1

152
Views
0
Helpful
1
Replies
CreatePlease to create content