Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ASDM won't run

I just got a new ASA 5510 and upgraded to ASA 8.0 using the ASDM. Then I upgraded the ASDM to 6.0 through the CLI using tftp. They both upgraded and loaded correctly as I can see them both listed when I do a 'sh ver' but nor I cannot connect to the ASDM.

I didn't change the management IP address (it's still 192.168.1.1) and I was able to hit it before the update. Now when I try to access it through a browser I get nothing but 'page cannot be displayed'. Can anyone help me with this?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: ASDM won't run

Hi Quantin

You are welcome. Please do not forget to check "resolved authors issue" for the comment.

Regards

3 REPLIES

Re: ASDM won't run

Hi Quinton

Make sure http server enable command exists in config

Also issue the following commands in enable mode and please paste the results here.

dir

sh asdm image

Regards

New Member

Re: ASDM won't run

For some reason the 'http server enable' command was not in the config after I upgraded to ASA 8.0 so I added it and am now in the ASDM. Thank you very much for your help.

Re: ASDM won't run

Hi Quantin

You are welcome. Please do not forget to check "resolved authors issue" for the comment.

Regards

1290
Views
5
Helpful
3
Replies
CreatePlease to create content