Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

Assign third party cert to SSL/VPN

ASA v8.3

ASDM v6.1

We don't have a verisign cert, we use an in-house CA for all our certs.

I've created a new cert from our Windows 2003 server CA and exported it, then imported it into the asa. I can see the cert sitting in the CA certificates section of the ASDM.

However, when I go to the SSL Settings to assign the cert to an interface, no certs show up. The box that pops up talks about enrolling trustpoints. All the readme's I've been to talk about this trustpoint section under Certificates. It's not there on mine. No where. So, I'm stuck. I'd add it by the command line, but I'm a little nervous to do so beings it's not showing up in the asdm anywhere like the readme says it should.

My whole purpose for this is to get the asa's cert to reflect it's host name on the cert, rather than an IP.

Curious if anyone else can advice me a bit on getting a third party cert installed and assigned properly? Am I ok using the command line here? I'm not concerned about using a CRL with this either.

Thank You

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Assign third party cert to SSL/VPN

Hi ..

I suggest to go over the below link .. make sure you follow the steps as per the document.

http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a00808b3cff.shtml

Please rate helpful posts.

2 REPLIES

Re: Assign third party cert to SSL/VPN

Hi ..

I suggest to go over the below link .. make sure you follow the steps as per the document.

http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a00808b3cff.shtml

Please rate helpful posts.

Community Member

Re: Assign third party cert to SSL/VPN

Thank you Fernando!

236
Views
0
Helpful
2
Replies
CreatePlease to create content