Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Backup ISP Links

I am trying to setup a Backup ISP for an ASA5505. I have successfully configured the interfaces, routes and tracking. One interface is called outside and the other is called failover. When the cable is pulled from the outside interface, the failover route becomes active. However, no traffic is going from the inside interface through the failover interface. I can reach the failover interface via ASDM or putty. It seems like I may have a nat issue from inside to the failover interface. Any help would greatly be appreciated. Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

The NAT looks OK.Shouldn't

The NAT looks OK.

Shouldn't the failover interface be security-level 0?

By default, same-security traffic is not permitted inter-interface.

2 REPLIES
Hall of Fame Super Silver

The NAT looks OK.Shouldn't

The NAT looks OK.

Shouldn't the failover interface be security-level 0?

By default, same-security traffic is not permitted inter-interface.

New Member

That makes sense. I will set

That makes sense. I will set it to 0 and give it a try. Thank you.

36
Views
0
Helpful
2
Replies