Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Anonymous
N/A

Bad disk0:/ (onboard flash) on ASA

Hello, I was wondering if anyone knows the configuration registry code to force an ASA to boot from the saved configuration on a flash drive? I'm looking for a 0x? solution. Any help would be appreciated!!

2 REPLIES
New Member

Re: Bad disk0:/ (onboard flash) on ASA

I am unaware of the ability to use the usb flash drive not are there any 0x commands I am aware of.

Closest you can get is the password recovery procedure but even that will not give you exactly what you are asking.

Anonymous
N/A

Re: Bad disk0:/ (onboard flash) on ASA

Well, what I'm trying to do is to force it to boot and get its config from disk1:/ which is a small 512MG SANDISK Compact Flash card. Currently the config shows the following:

boot system disk0:/asa722-k8.bin

boot config disk0:/TFTP/10.10.10.40/asa722-k8.bin

I can't change that once I boot because the onboard flash is damanged, so now I have it booting from a TFTP server but I also want to force it to load the config. I guess I should just send them off for RMA huh?

I want to force it to have this config:

boot system disk1:/asa722-k8.bin

boot config disk1:/TFTP/10.10.10.40/asa722-k8.bin

I don't see how though since it won't save any configurations my TFTP workaround is not working :-( Thanks anyway

295
Views
0
Helpful
2
Replies