Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

bandwidth management in ASA 5500

Hi all,

pls suggest how can we terminate 4 mbps link into 2/1/1 in ASA ,also how can we manage bandwidth ?

pls give the proper link

Regards

mpak

1 REPLY

Re: bandwidth management in ASA 5500

Without further detail, the best I can tell you is to read the ASA Traffic Shaping documentation here:

http://www.cisco.com/en/US/docs/security/asa/asa82/configuration/guide/conns_qos.html#wp1074879

That will allow you to assign a CIR (committed-information rate), Burst rate, etc.

If you have a single 4mbps link, you won't be able to physically partition it into 2/1/1 on the ASA per-se, but you can use traffic shaping and QoS to carve out chunks of bandwidth for certain IP ranges.

Hope that helps. Please rate if this post was useful to you.

Cheers,

Tim

735
Views
0
Helpful
1
Replies