I have a pair of 5520s with the LAN/STATE interface on a Gi0/2. Some hoser configured the interfaces as 100/full and connected them to 100/full 100M switchports. You evidently can't change the ASA interfaces with failover enabled. Is there an easy way to move those connections to auto/auto 1000M switchports without tearing down failover?
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...