Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

bridge or tunnel

need to create a transport for traffic between a ATM sub-interface and a trunked GigabitEthernet.

Any ideas?

1 REPLY
Community Member

Re: bridge or tunnel

Bridge the ATM sub-interface and the respective VLAN.

bridge 1 protocol ieee

interface atm0/0.1

bridge-group 1

atm route-bridged ip

Check this link also:

http://www.cisco.com/en/US/products/sw/iosswrel/ps5014/products_feature_guide09186a0080087970.html

I hope this helps

122
Views
0
Helpful
1
Replies
CreatePlease to create content