Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

cable based failover config on asa 5520

hi,

we had 1 5520 & have purchased 1 new asa 5520. we want to make cable based active/active failover on this 2 devices. can someone help me with sample config? i found some docs but that were for pix. i need on asa.

6 REPLIES
Silver

Re: cable based failover config on asa 5520

New Member

Re: cable based failover config on asa 5520

could u please tell me my config is correct or wrong:

interface GigabitEthernet0/3

description STATE Failover Interface

failover

failover link failover GigabitEthernet0/3

failover interface ip failover 192.168.50.1 255.255.255.0 standby 192.168.50.2

Silver

Re: cable based failover config on asa 5520

You'll need to do that for each context that you have. You also need to configure the failover groups.

See this doc. Will show you everything you need for A/A failover.

http://www.cisco.com/en/US/customer/products/ps6120/products_configuration_guide_chapter09186a008063b31a.html#wp1096075

Thanks,

Chad

New Member

Re: cable based failover config on asa 5520

can't active/standby filover be configured in asa in cable based failover mode?

Silver

Re: cable based failover config on asa 5520

Your original post said Active/Active. Which one are you trying to do?

Chad

New Member

Re: cable based failover config on asa 5520

if i connect the 2nd asa in cable based failover mode, will the replication be done automatically? don't i need to specify the lan, wan side ip address also??

303
Views
0
Helpful
6
Replies