02-19-2010 12:29 AM - edited 03-11-2019 10:12 AM
Hello,
I have two firewalls in layer 3 mode, single context, active - standby.
Is it possible to make the primary after a failure to become active again, without having to type failover active?
thanks,
george
02-19-2010 03:07 AM
No.
Preempt only work in Active/Active failover mode.
Active/Active work in multiple context mode.
02-19-2010 06:19 AM
That is correct. Preempt is only available in multiple context act/act mode. Pls. refer to the table in the below command reference link below:
http://www.cisco.com/en/US/docs/security/asa/asa82/command/reference/p.html#wp1868647
-KS
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: