Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

Can I use two failover pix in a meanwhile?!

Hi,

I have a problem, I need to migrate two Pix firewall from a network to another.

I have this situation:

PIX active actually has been disconnected from the network and the standby pix becomes active and the failover is now switched off.

I need to move the old active router to another network, but now it has the same mac-address of the pix that now is working as active, and I cannot do it.

How can I use all two pix together for a meanwhile?!

Can you help me?!

Thanks a lot

Best Regards

Cinzia

1 REPLY
Silver

Re: Can I use two failover pix in a meanwhile?!

It is possible through Active / Active Failover, which is available in PIX version 7.x.

Try this link:

http://www.cisco.com/en/US/customer/products/ps6120/products_configuration_guide_chapter09186a008045247e.html#wp1096075

153
Views
5
Helpful
1
Replies
CreatePlease to create content