Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)

Can't authenticate ASA Trust Point

hi all,

i'm trying to create a trust point and an identity certificate at the same time but the ASA can't seem to allow me.

i tried to do it both in CLI and ASDM but no avail. anything i'm missing here?

 

ASA5505(config)# crypto ca authenticate TP-5505

ERROR: receiving Certificate Authority certificate: status = FAIL, cert length = 0

 

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

It looks like your trying to

It looks like you're trying to authenticate your device's issued identity certificate before you have told the ASA to trust the issuing CA.

Have a look at this Cisco document and refer to Step 3 (paragraph 8 onward specifically)

2 REPLIES
Hall of Fame Super Silver

It looks like your trying to

It looks like you're trying to authenticate your device's issued identity certificate before you have told the ASA to trust the issuing CA.

Have a look at this Cisco document and refer to Step 3 (paragraph 8 onward specifically)

thanks marvin!been looking

thanks marvin!

been looking around for a good cisco doc.

i let my google skills down while trying to figure out my ASA config.

198
Views
0
Helpful
2
Replies
CreatePlease to create content