Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

can't get cursor on pix

Hi,

We configured unrestricted pix for failover long time ago.

We need use it without standby now, and can't get cursor.

We've got the following message :

" pixfirewall>

No Response from Mate

Failover LAN Failed"

how could we get cursor?

4 REPLIES

Re: can't get cursor on pix

pl try by disabling failover...... I since since failover is enabled PIX is trying to mate with standby device,,, since it is not finding it;;;; it may be telling no respone from mate.Hope it works

New Member

Re: can't get cursor on pix

if i may ask do u mean that you configured another pix machine for standby or is it that you configured a standby ip address on the existing router pls i need to know in order to solve your question

New Member

Re: can't get cursor on pix

if i may ask do u mean that you configured another pix machine for standby or is it that you configured a standby ip address on the existing router pls i need to know in order to solve your question

New Member

Re: can't get cursor on pix

Hi,

yes,we've configured another pix as failover.

We connected the other pix and we can get cursor now.

We remove failover configuration and we can use it alone.

Thanks every body

131
Views
0
Helpful
4
Replies