Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

Can't get HTTP in.

I can't get into my internal web server from the internet. I can ping the 501 from outside, and can ping from the 501 to the web server. But can't connect to the web page.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Can't get HTTP in.

The configuration looks good !

Have you set the correct default gateway on the web server, PIX IP address.

Have you done a :

clear xlate

Try if you are able to open the page from the inside with the browser.

Note that the clear xlate will reset the Adress translation table.

sincerely

Patrick

1 REPLY

Re: Can't get HTTP in.

The configuration looks good !

Have you set the correct default gateway on the web server, PIX IP address.

Have you done a :

clear xlate

Try if you are able to open the page from the inside with the browser.

Note that the clear xlate will reset the Adress translation table.

sincerely

Patrick

139
Views
0
Helpful
1
Replies
CreatePlease to create content