Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

Can't ping inside interface of PIX

I have a PIX 501 at a remote location and I seem to allow echo-repllies from the inside interface. I have tried ACL's and ICMP commands without success. I have attached a copy of the config.

3 REPLIES
Hall of Fame Super Blue

Re: Can't ping inside interface of PIX

Hi

Just to clarify, are you tring to ping the inside interface of the remote pix from the outside of the pix.

If so you cannot do this with pix ver 6.x which i'm assuming is what your pix is running.

You can ping the outside interface form the outside, the inside interface from the inside and you can ping through the pix but you can't ping the outside interface from the inside and vice-versa.

HTH

Jon

Green

Re: Can't ping inside interface of PIX

If you are vpn'ing to the remote pix you can enter the following command in the pix to allow you to ping the inside interface address.

management-access inside

Bronze

Re: Can't ping inside interface of PIX

make sure the IP you are pinging from belongs to the NY_office subnet... otherwise you will need to have the other subnets in the icmp permit command.

HTH

538
Views
0
Helpful
3
Replies
CreatePlease to create content