Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Can we do MAC Address based routing in ASA5540

I have a network setup where two servers from inside need to communicate with a remote network via 2 VPN gateways. The destinations are same.

However, the chalange is each server need to follow it's own VPN gateway. Since i can't configure PBR (policy based routing) in ASA, can i configure something like MAC Address based routing. I can't use destination based routing since the remote network are reachable from the both VPN Gateways.

Advise needed.

Thanks in advance.

Regards,

R.Siva

Network Security Engineer.

1 REPLY
Gold

Re: Can we do MAC Address based routing in ASA5540

Hi

I am not shure i follow you correct here.

You want 2 servers to speak to the same network but over two different vpn units ?

If this is so then this could work

Just set the route to the other network on server 1 to the vpn gate 1

and route the other network from server 2 to the vpngate 2.

in windows the command is route add.

good luck

hth

380
Views
0
Helpful
1
Replies
CreatePlease to create content