Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cannot access ASA services module

I have two 6513-E switches that I have enabled VSS on to make one logical switch.

These switches have ASA service modules in slot 9, and they show up when I do a "show mod"

When I try to get into the module by issuing the command

session switch 1 slot 9 proc 1

it tries to contact 127.0.0.91

and then times out.

Is there something I am doing wrong?           

2 ACCEPTED SOLUTIONS

Accepted Solutions
Hall of Fame Super Silver

Cannot access ASA services module

That is the correct command. You might also try "service-module switch 1 slot 9"

Does "show module" indicate the module status is OK?

Could there perhaps be stale connections that are using up the available console sessions? "show users" (from the switch cli) will show any active (or inactive) connections.

New Member

Cannot access ASA services module

Hi colin,

have you assign VLAN to slot 9 or ASASM.??

if not you will have to assign VLAN to ASASM to access the firewall as ASASM doesnt have any physical interface.

Regards

Pankaj

2 REPLIES
Hall of Fame Super Silver

Cannot access ASA services module

That is the correct command. You might also try "service-module switch 1 slot 9"

Does "show module" indicate the module status is OK?

Could there perhaps be stale connections that are using up the available console sessions? "show users" (from the switch cli) will show any active (or inactive) connections.

New Member

Cannot access ASA services module

Hi colin,

have you assign VLAN to slot 9 or ASASM.??

if not you will have to assign VLAN to ASASM to access the firewall as ASASM doesnt have any physical interface.

Regards

Pankaj

152
Views
0
Helpful
2
Replies
CreatePlease login to create content