Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Cannot access files in FWSM flash

I have a fwsm running 4.0(5) stuck where I cannot access any of the files in the flash. This is a test module (for now) that was loaded with a bad configuration file. When I try to access the flash I get "Configuration update in progress by another process". I get the same message when I try "write erase".

Any ideas on how I can fix this?

Thaks.

1 REPLY
Cisco Employee

Re: Cannot access files in FWSM flash

pls. refer bugs CSCsv83322 and CSCsu83857

Make sure there is no session sitting at a "more" prompt.

Have you tried a reload?

524
Views
0
Helpful
1
Replies
CreatePlease to create content