Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cannot load ASDM after upgrade

Not sure where I slipped up, but when I try to load ASDM I get an unable to load ASDM from <ip address> message.

wbdcfw# sh ver

Cisco Adaptive Security Appliance Software Version 8.2(1)

Device Manager Version 6.2(1)

Compiled on Tue 05-May-09 22:45 by builders

System image file is "disk0:/asa821-k8.bin"

Config file at boot was "startup-config"

wbdcfw up 3 mins 2 secs

Hardware: ASA5505, 256 MB RAM, CPU Geode 500 MHz

Internal ATA Compact Flash, 128MB

BIOS Flash M50FW080 @ 0xffe00000, 1024KB

...

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: Cannot load ASDM after upgrade

Make sure you have the following in ur config

http server enable

asdm image disk0://xxx

3 REPLIES
New Member

Re: Cannot load ASDM after upgrade

Make sure you have the following in ur config

http server enable

asdm image disk0://xxx

New Member

Re: Cannot load ASDM after upgrade

I didn't have 'http server enable' in my config. Thanks!

New Member

Re: Cannot load ASDM after upgrade

You must also specify which addresses are allowed to access it:

http xx.xx.xx.xx netmask [interface] i.e:

http 192.168.100.0 255.255.255.0 inside

or

http 0 0 outside for all of the outside IPs. If all of that is done, clear your browser's cache/cookies, close all browser windows and re-open.

402
Views
0
Helpful
3
Replies
CreatePlease to create content