Cannot pass telnet traffic to solaris server through FWSM
I'm trying to allow telnet traffic from one vlan to another through the FWSM, and when I try to telnet from my windows machine to any solaris server on the other side, I get black screen (meaning port is opened), however, I do not get the prompt for username and password. if the same is done from any machine on the solaris side, the connection gets through.
Any guesses on why is this happening? BTW, I am allowing IP any any acl on both sides, and not doing any translation on either way...
If somebody give a proper solution, I will give a red tick and 5 points
Re: Cannot pass telnet traffic to solaris server through FWSM
The issue is solved. Actually when we snooped the telnet traffic of the solaris server. we found the server is dropping the packets. There is an inbound telnet traffic to the server and there is no return traffic from the server. so we changed the ip address of the existing interface, and played with the routing table, and it worked fine!
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...