Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Capturing FWSM-sourced traffic

Hi,

Has anyone suggestions as to the best way to capture traffic sourced from a FWSM module running 3.2(3).

I have tried the capture feature but this may only work on traffic across the box.

Thanks

Mark

1 REPLY
New Member

Re: Capturing FWSM-sourced traffic

If you cannot capture the traffic using the capture feature by specifying some tight acl's then you may want to throw in a sniffer if that is possible. You would get more information than the FWSM capture would provide even if it did work. Maybe too much even. I have had a couple of FWSM issues that only sniffers could capture.

124
Views
0
Helpful
1
Replies
CreatePlease to create content