Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

capturing in PIXOS

Hey...

I'm trying to capture all traffic back and forth between an inside host and another organization's ftp server.

I have an access-list, one line:

access-list follett standard permit host 12.172.137.116

I have a capture command:

capture follett_outside access-l follett int outside

But packets are captured in only 1 direction - from my host to the foreign server. Packets returning from the server are not captured.

I know there are such packets, as I'm capturing on the workstation at the same time, and I can see them.

If the doc I've looked at explains this, I have failed to understand...

Anyone want to point me in the right direction?

Much appreciated...

1 ACCEPTED SOLUTION

Accepted Solutions

Re: capturing in PIXOS

Try this capture

(config)#access-l cap1 permit ip any host 12.172.137.116

(config)#access-l cap1 permit ip host 12.172.137.116 any

(config)#cap cap1 access-l cap1 in outside

then generate traffic either direction

show cap cap1 -> will show output

to remove cap1 / acl

(config)#no cap cap1

(config)#no access-l cap1

ensure cap is completely remove

show cap

-regards

3 REPLIES

Re: capturing in PIXOS

Try this capture

(config)#access-l cap1 permit ip any host 12.172.137.116

(config)#access-l cap1 permit ip host 12.172.137.116 any

(config)#cap cap1 access-l cap1 in outside

then generate traffic either direction

show cap cap1 -> will show output

to remove cap1 / acl

(config)#no cap cap1

(config)#no access-l cap1

ensure cap is completely remove

show cap

-regards

Community Member

Re: capturing in PIXOS

Thanks much Jorge - that did it.

(Surprised to learn that "capture this host" =! "capture this host to any, any to this host", but hey, it's good to learn something new every day!)

Re: capturing in PIXOS

You are welcome.. glad to help.. thanks for rating.

-regards

119
Views
0
Helpful
3
Replies
CreatePlease to create content