Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

Cat6513 SPA module problem

Hi Dear All:

I have a sip7600 ssc-400 carrier with SPA Ipsec module , when I install the carrier with the spa in the cat6513 slot13 and enable the power for that module the module dose not com up and I get this error masseage "FRU-power failed"

and here what the cat display to me

SW-6513B#sh power status module 13

Pwr-Requested Pwr-Allocated Admin Oper

Slot Card-Type Watts A @42V Watts A @42V State State

---- ------------------ ------- ------ ------- ------ ----- -----

13 7600-SSC-400 226.80 5.40 - - on off (FRU-ower failed)

So please if any one has any knowleg about this error help.

125
Views
0
Helpful
0
Replies
CreatePlease to create content