Hi - i have started configuring a cat6k on IOS 12.2(18)SXF7 and a FWSM on 3.2.2 with ipv6. In the past we used to have a chassis redundant layout, two 6ks with two FWSMs, FWSMs inside vlan routes towards a HSRP address of the 6k's (static routing).
Now I seem to discover that neither my 6k's IOS level supports sort of a ipv6HSRP nor seems the FWSMs 3.2.2 code to support OSPFv3.
How am I supposed to setup a redundant failover layout with IPv6 then?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...