Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Change configuration

Hi,

I have a PIX 525, erase configuration with "write erase" after boot the follow message"Cryptochecksum (changed)" displayed, and I don't have prompt for continued the configuration. What's ?

1 REPLY
Silver

Re: Change configuration

Try the following commands in configuration mode:

Pix#config t

Pix(config)#ca zeroize rsa

Pix(config)#ca generate rsa key 1024

Pix(config)#ca save all

Pix(config)#write mem

Pix(config)#reload

That should fix the problem, but in order for the key to generate, you need to ensure that the PIX has a host name and domain name configured. If you need to do that too use these commands:

hostname xxxxxx

domain-name xxxxx.com

240
Views
0
Helpful
1
Replies