On my ASA if I SSH to it I can put the same username and password I use when I use the ASDM, however when I tlenet to the ASA it just says password, I simply put in "password" and it lets me, then asks for my username and password, how do I change this first telnet password?
1.) If I login via telnet I get prompted for a password which I enter, then I get to the user mode (I think) and then type enable and it have to enter my priviliged 15 username and password which I use for the ASDM or SSH.
2.) If I login via SSH I have to enter my level 15 username and password, then when I type enable I have to put my level 15 password in again and not the enable secret password I use in telnet.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...