09-20-2007 06:21 AM - edited 03-11-2019 04:14 AM
Hi..
I have a PIX with 5 Intefaces at present. There is an Inside zone with security level 100 and another zone 'A' with security level 99.The next zone comes with security level 80 only.
I would like to add a new 6th Interface with a security level in between Inside and level 'A'. The PIX is operational . Can I reduce the secutiry level of 'A' to say 95 and give the new interface a security level of 98. will the PIX take in the command, and if does will it cause any issues.
rgds
Rajesh
Solved! Go to Solution.
09-20-2007 07:25 AM
Rajesh,
In short the answer is yes! The security-level command with take effect on each new packet put into the state table. However a quick reboot is always best if possible
Bill
09-20-2007 07:25 AM
Rajesh,
In short the answer is yes! The security-level command with take effect on each new packet put into the state table. However a quick reboot is always best if possible
Bill
09-22-2007 05:34 AM
Thank You Bill....
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: