Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco ASA 5505 and Cisco Small Business WRVS4400N VPN tunnel

Good Morning,

I'm trying to establish a VPN tunnel between our main office running a Cisco ASA 5505 [8.3(2)] and a remote user using a Cisco Small Business WRVS4400N firmware version V2.0.1.3.

The Cisco ASA 5505 is already configured to allow incoming IPSec VPN connections via the Cisco VPN Client.

Is this possible, and if so, how would I go about doing so? The remote user has a static IP address as well as the main office.

Any information provided would be appreciated. Thanks

Good Morning,

I'm trying to establish a VPN tunnel between our main office running a Cisco ASA 5505 [8.3(2)] and a remote user using a Cisco Small Business WRVS4400N firmware version V2.0.1.3.

The Cisco ASA 5505 is already configured to allow incoming IPSec VPN connections via the Cisco VPN Client.

Is this possible, and if so, how would I go about doing so? The remote user has a static IP address as well as the main office.

Any information provided would be appreciated. Thanks

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Cisco ASA 5505 and Cisco Small Business WRVS4400N VPN tunnel

Yes, this will work.  I have it up and running.  Use the site to site vpn wizard on the ASA and then on the WRVS4400N, make sure to select the settings below.  *You need to disable PFS on the ASA either during the wizard of afterward under vpn properties/advanced.

Phase 1 >

Mode = IKE w/ Preshared Key

Encryption = 3DES

Auth = SHA1

Group = 1024 bit

key lifetime = 86400

Phase 2 >

Encryption = 3DES

Auth = SHA1

PFS = Disable

Group = 1024 bit

key lifetime = 3600

2 REPLIES
New Member

Cisco ASA 5505 and Cisco Small Business WRVS4400N VPN tunnel

Anyone?

New Member

Cisco ASA 5505 and Cisco Small Business WRVS4400N VPN tunnel

Yes, this will work.  I have it up and running.  Use the site to site vpn wizard on the ASA and then on the WRVS4400N, make sure to select the settings below.  *You need to disable PFS on the ASA either during the wizard of afterward under vpn properties/advanced.

Phase 1 >

Mode = IKE w/ Preshared Key

Encryption = 3DES

Auth = SHA1

Group = 1024 bit

key lifetime = 86400

Phase 2 >

Encryption = 3DES

Auth = SHA1

PFS = Disable

Group = 1024 bit

key lifetime = 3600

945
Views
0
Helpful
2
Replies