Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

Cisco ASA 5505 - locks up after about 2 days uptime

I am using a ASA 5505 with two IPSec Tunnels & Remote users IPSec VPN's. I am finding that the unit locks up after about 2 days uptime. It remains visible locally so I can do an immediate system reload but there is no internet access, the tunnels gop down & the remote VPN users are unable to connect. After the system reload the unit is fine again until the next time. If I reload unit via ASDM it works for few minutes and locks again. But after power off/on it works for few days. Unit Version is 7.2(4).

1 REPLY
Cisco Employee

Re: Cisco ASA 5505 - locks up after about 2 days uptime

check interface speed and duplex settings.hard code it and avoid auto settings.

also,change the outside interface from e0/0 port to some other port.that would confirm if it's the e0/0 port which is bad.

Regards,

Ssuhil

537
Views
0
Helpful
1
Replies
CreatePlease to create content