I am using a ASA 5505 with two IPSec Tunnels & Remote users IPSec VPN's. I am finding that the unit locks up after about 2 days uptime. It remains visible locally so I can do an immediate system reload but there is no internet access, the tunnels gop down & the remote VPN users are unable to connect. After the system reload the unit is fine again until the next time. If I reload unit via ASDM it works for few minutes and locks again. But after power off/on it works for few days. Unit Version is 7.2(4).
check interface speed and duplex settings.hard code it and avoid auto settings.
also,change the outside interface from e0/0 port to some other port.that would confirm if it's the e0/0 port which is bad.
Regards,
Ssuhil
Getting Started
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
