Cisco ASA 5505 not passing traffic (Possible NAT or ACL issue)
I have an ASA 5505 in front of (7) devices. Each device is statically NAT'd to an external IP address with ACLs restricting the specific ports. This setup works perfectly on ASAs with a single host behind the ASA. Below is a sample config of the ASA. Any help would be greatly appreciated!
Re: Cisco ASA 5505 not passing traffic (Possible NAT or ACL issu
The devices I am trying to place behind the firewall are currently running on the network using the addresses defined in the NAT rules. The internal devices can ping out just fine, but the external hosts are unable to ping through the firewall or poll the internal devices as required. I am beginning to think it may be an ARP issue, but I want to rule out the NAT/ACL rules first.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...