Hi There,
I have Cisco ASA 5510-K8 where I can't use Eth 0/3. Below is the Sh ver output which says Eth 0/3 is not licensed. It has base license at the moment and I believe that we need to have security plus license to enable Eth 0/3 but would like to confirm the exact license as Cisco has many options with different types.
Cisco ASA 5510# sh version
Cisco Adaptive Security Appliance Software Version 7.0(6)
Device Manager Version 5.0(6)
Hardware: ASA5510-K8, 256 MB RAM, CPU Pentium 4 Celeron 1600 MHz
Internal ATA Compact Flash, 256MB
BIOS Flash AT49LW080 @ 0xffe00000, 1024KB
Encryption hardware device : Cisco ASA-55x0 on-board accelerator (revision 0x0)
Boot microcode : CNlite-MC-Boot-Cisco-1.2
SSL/IKE microcode: CNlite-MC-IPSEC-Admin-3.03
IPSec microcode : CNlite-MC-IPSECm-MAIN-2.04
0: Ext: Ethernet0/0 : address is 000a.b89c.eca0, irq 9
1: Ext: Ethernet0/1 : address is 000a.b89c.eca1, irq 9
2: Ext: Ethernet0/2 : address is 000a.b89c.eca2, irq 9
3: Ext: Not licensed : irq 9
4: Ext: Management0/0 : address is 000a.b89c.ec9f, irq 11
5: Int: Not licensed : irq 11
6: Int: Not licensed : irq 5
Licensed features for this platform:
Maximum Physical Interfaces : 4
Maximum VLANs : 10
Inside Hosts : Unlimited
Failover : Disabled
VPN-DES : Enabled
VPN-3DES-AES : Enabled
Security Contexts : 0
GTP/GPRS : Disabled
VPN Peers : 50
This platform has a Base license.
Thanks in Advance.
Prabjeet
