I have one cisco asa5510 and i use the cisco ADSM 5.0 to configure the firewall. and i set the eth0/0 ip as 192.168.1.1/24, eth0/1 ip as 192.168.10.1/24 and running dhcp. the two interface is up and i use the hyperterminal, try to ping from network 192.168.10.0/24, it success. and then i use the xp command promt to ping, unsussess. how this routing should be implement at the ADSM manager? can somebody teach me? thank you.
we need some more information such as where is your windows XP computer placed in, is it in E0/0 or E0/1?
by default Cisco ASA configure the E0/0 as outside interface which is Exposed to internet and known as unsecured Zone (0%)and tagged as Vlan 2
and E0/1 and other ports are assigned to Vlan 2 and all interfaces are belongs to inside interface and in firewall aspects that is known as Secured Zone (100%)
as i have mentioned above outside 0% secure and Inside 100%, which are percentage. for example you can ping from inside interface to outside interface and you'll get the reply but you cant ping from outside to inside because firewall will block them by default.
now after you have understand the concept, we have to create a statice route from your ASDM to source 0.0.0.0 and destination also 0.0.0.0 and gateway has to place as 192.168.10.1 if your computers are beside in interface e0/1.
hope this will help you.... please reply us your update...
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...