11-13-2011 04:06 AM - edited 03-11-2019 02:49 PM
Hi
Sorry if this i a silly Q, but im normaly only dooing IOS config.
I have little problem when trying to setup this unit.
It boots ASA software 8.0.4 fine.
When i go to enable mode and into configuration mode and try to configure ip on an interface i have a problem.
ciscoasa(config)# int
ciscoasa(config)# interface man
ciscoasa(config)# interface management 0/0
ciscoasa(config-if)# ?
Interface configuration commands:
default Set a command to its defaults
description Interface specific description
dhcp Configure parameters for DHCP client
duplex Configure duplex operation
exit Exit from interface configuration mode
help Interactive help for interface subcommands
no Negate a command or set its defaults
shutdown Shutdown the selected interface
speed Configure speed operation
ciscoasa(config-if)#
I am not allowed to set anything on this interface, same goes for the 8 Giga interfaces on the unit.
I did try to upload the new software 8.4.2 from rommon using TFTP.
It boots 8.4.2 fine, but have same problem as in 8.0.4.
I did try to create a user haveing priv 15 and logging on as that user. It gives the same.
The firewall is not in transparent mode.
Anyone who knows what i am doing wrong.
Regards
11-13-2011 11:36 AM
Hello Jaynet,
There are no silly questions, can you do a sh mode and provide us the output.
Regards,
Julio
11-13-2011 03:27 PM
:-p
Okay, i did not se that one comming.
I was in multible mode. After a change to single mode and a short reboot. Everything was back to the way i was use to.
Thanks for the help..
11-13-2011 04:40 PM
Hello Jaynet,
Good to see that now everything is back to normal.
Please mark the question as answered.
Best regards,
Julio
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide